It is with deep regret that we announce the closing of Windham Weaponry. Our website/online retail ordering system will remain active through Tuesday night, Sept 12. We will do our best to ship all orders this week and early next week. No credit card will be charged until the order is shipped.
Twelve years ago, when we started Windham Weaponry, our shareholders and longtime employees were excited to continue the traditions and spirit of Bushmaster Firearms, after the new owners decided to leave Maine.
We built WW into a company we could be proud of providing outstanding customer service, high quality products, as well as a great place for our dedicated employees to work.
The last few years have been a very challenging time for the firearms industry, and we have struggled to keep the WW dream alive for as long as possible. Unfortunately, we have not been able to meet our loan obligations with the bank after they worked with us as much as they could.
There was a glimmer of hope when we were negotiating with an investor to help keep WW alive and healthy, but that just fell through.
We have begun discussions with Keenan Auction Company to determine the best course of action for a full liquidation which should happen within the next month or so.
Our shareholders and employees truly appreciate your loyal support all of these years.
This JP Reduced Power Spring Set – when used with quality Mil-Spec trigger/hammer components like Windham Weaponry parts, and a good anti-seize grease – can achieve a usable 4.5 to 5 lb. pull trigger. For installation of these springs, simply remove the trigger & hammer pins from the receiver – driving the hammer & trigger pins out with a plastic mallet and drift pin. Then, replace the existing fire control springs with the new JP Set. Note that one end of the disconnector spring is slightly wider than the other – make sure to insert this wider end into the trigger so that the narrower end is exposed to contact the disconnector. Similarly, because it is easy to accidentally reverse, make sure to install the hammer spring with the “loop and legs”on the upper side – the same way the original came off. After the trigger components are reinstalled and secured, apply an appropriate lubricant to the sear and disconnector engagement surfaces. Optimal for this application is a good quality anti-seize grease.
Join WaitlistBe the first one to know when this item arrives in stock. Please leave your valid email address below.